Difference between revisions of "Batch Mode"
Jump to navigation
Jump to search
m (→References) |
|||
| Line 12: | Line 12: | ||
=== Other International Definitions === | === Other International Definitions === | ||
| − | <!-- Insert here definitions from international organizations, if available. Each new definition should be formatted as a heading level 4, followed by the unformatted text of the definition. An example follows below: | + | <!-- Insert here definitions from international organizations, if available. Each new definition should be formatted as a heading level 4, followed by the unformatted text of the definition. An example follows below: |
==== United Nations’ Definition ==== | ==== United Nations’ Definition ==== | ||
| − | + | Insert the definition found in the document “2009 UNISDR Terminology on Disaster Risk Reduction” (this is an example). --> | |
=== National Definitions === | === National Definitions === | ||
| Line 41: | Line 41: | ||
<!-- Add category, i.e. [[Category:Main]] --> | <!-- Add category, i.e. [[Category:Main]] --> | ||
[[Category:DIESIS-Glossary]][[Category:Simulation]] | [[Category:DIESIS-Glossary]][[Category:Simulation]] | ||
| + | {{#set:defined by=EU project}} | ||
Revision as of 01:30, 10 June 2015
Contents
Definitions
European Definitions
DIESIS project
The DIESIS project [1] gives the following definition:
The batch mode of the simulator is used to run many simulations automatically without having to interact with the simulation environment. The scenarios to run and possible fault behaviours are specified in a beforehand.
